Of course not, my friend....you're a racer....we take responsibility for our decisions, n'est ce pas? My point was that the shop has been honest and straightforward, and has been trying to save the OP spending more than necessary. I do the same, for my customers, as does every honest pro, in any line of work.
Modern cars are rolling computers, and we all need to use computers, to diagnose them. If the computers are wrong, then, USUALLY, we are also wrong. Every now and then, a good tech will have a hunch, based on experience, which leads him (her) to look past the computer's diagnosis.
We live in a "politically correct" world. Maybe that shop's tech "felt" the same hunch that I have.....but he's got to follow the computer's information, hunch or not....or somebody's going to threaten to take him to court. If he goes to court, well, he's going to need to have followed the prescribed ritual. This shop did that.
Last edited by bmwdirtracer; 07-12-2018 at 11:35 PM.
Chris Powell
Racer and Instructor since, well. decades, ok?
Master Auto Tech, owner of German Motors of Aberdeen
BMWCCA 274412
German Motors is hiring ! https://www.bimmerforums.com/forum/s...1#post30831471
READ THE SERVICE BULLETIN:
2. If any of the following low-pressure sensor fault codes (29F3, 2A2D, 119201, 119202, 11A201, 11A202, 11B211) are stored in the DME, replace the low-pressure fuel sensor. Follow Repair Instruction REP 13 53 594. Clear the fault memory and continue to step 6.
Chris Powell
Racer and Instructor since, well. decades, ok?
Master Auto Tech, owner of German Motors of Aberdeen
BMWCCA 274412
German Motors is hiring ! https://www.bimmerforums.com/forum/s...1#post30831471
NEW PROBLEM YOU mention "sucking jet pump. where is this located on 2007 525I (e60)
FRANK12,
It's preferred and recommended for you to start your own thread.
+1.
Welcome to the forum, Frank.
The thread you tacked onto has really nothing to do with your issue. You need to start your own thread. It's easy, and we'll be glad to assist.
Chris Powell
Racer and Instructor since, well. decades, ok?
Master Auto Tech, owner of German Motors of Aberdeen
BMWCCA 274412
German Motors is hiring ! https://www.bimmerforums.com/forum/s...1#post30831471
Bookmarks