Good Morning Friends;
I use the below software package installed on my lab top Windows 8.1 to Diagnose BMW Z3 1998 2.8 Roadster MS 41.0, M52, things are working properly, only when I click the page of Analog 2, I get the error shown on the attached picture.
If any advice available I will be grateful
Software Package
INPA 5.06
EDIABAS 7.3.0
NCS Expert 4.0.1
NCS Dummy 0.6.04
Tool32 4.03
WinKFP 5.3.1
BMW Coding tool v2.5.0
I would first try to use the ms41.1 profile. 1998 is new enough to accept those commands.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
Ok, many thanks , i found almost similar problem raised in the forum long back but with no solution, via below link:
https://www.bimmerforums.com/forum/s...checkjobstatus
Bookmarks