Hello my son and I purchased the Bcables K+Dcan setup for our e60 and e46 cars. We installed the software on my laptop (64 bit windows 10) and everything went ok.
followed the directions supplied and connected to vehicle and nothing. cannot identify vehicle, and if I manual identify the vehicle it only lets me see the DME.
Progman/SSS doesn not load correctly and also will not connect to the vehicle.
didn't try the others but I am assuming the windows 10 is the problem.
anyone get this to work? anyone care to guide me through this with out making it sound like I am a dumb ass.. (which I probably am)
thanks
Level 1 Certified BMW tech.
I would verify that your COM port settings match first.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
yup did that, followed all the you tube and online help I could get. dont know what the problem is.
Level 1 Certified BMW tech.
Same problem here with E53 4.4 only dme and egs show up. have a trouble with the air suspension.. ( see picture ) Running on Windows 7
Ista.jpg
Last edited by vanders; 07-15-2018 at 07:44 AM.
I think i found the solution, there is also a 20 pin connector under the hood, in 2 days i have my 20 pin to obd cable, and can find out if it will work
Bookmarks