Autogeek.net Car Care Products
** 10% off @ Autogeek.net - PinnacleWax.com & Wolfgangcarcare.com - Coupon Code = clubmember
Results 1 to 2 of 2

Thread: Layered Coatings Possible?

  1. #1
    Join Date
    Aug 2009
    Location
    Northeast PA
    Posts
    43
    My Cars
    M6 (2013)

    Layered Coatings Possible?

    Does anyone know if you can use a product like Hydrosilex on top of Kamikaze ISM? My thinking is that the Kamikaze is (just guessing here...) the better, more durable product. So I was going to use Hydrosilex as a 'detailer / sealer' (like spray shine) on top of ISM for quick refreshes. I'm just asking to be sure there aren't any possible side-effects to doing so.

    Thanks in advance!

  2. #2
    Join Date
    Oct 2004
    Location
    Atlanta
    Posts
    7,806
    My Cars
    '73 Bavaria
    For over-the-counter coatings, I believe layering can be beneficial for a private DIY'er owner. But one must exercise caution that they are not attempting to "layer" by reapplying too quickly after a previous layer application. Coatings have transfer solvents(in most cases, I believe these are alcohol-based solvents).

    The reason OTC coatings may benefit from layering moreso than some other professional coatings, is that the thing that makes them user-friendly as an OTC coating is the same thing that limits the active ingredients(si02). The transfer-rich solvent mixture in OTC coatings will easily break down an previous coating layer if applied before cured to a healthy measure. To what specific healthy measure? That would be different from coating to coating but my advice is to not even consider layering over a coating within 24-48 hours. IR lamp treatment will not change this very much, if at all, based upon how IR lamp treatments actually work(which is different from what many people believe).

    Long story short:
    OTC coating and you want something a bit more than basic? Sure, layer. But wait 24-48 hours before reapplying. Too....always be RELIGIOUS about decontaminating before coating and between each corrective preparation step. My advice is to decontaminate every single time you lift your machine/pad from the paint to remove the residue with a mf towel. That will ensure you have the optimal bond of your original layer.

    Hope this helps.
    “The bitterness of poor quality remains long after the sweetness of low price is forgotten” – Benjamin Franklin

Similar Threads

  1. Metallic Ceramic Thermal barrier coatings
    By Douglas in forum Forced Induction
    Replies: 1
    Last Post: 02-20-2003, 03:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •