I am parting out 2 different engine, an M50B25TU from an E34 525i that had 194k miles and a M54B30 from an E46 330i with unknown miles. I was going to make one engine of the 2 but decided to go a different route.
The M50 had 194K miles and did run before being pulled (I have videos), however the engine block was worn down about a mm overbore from piston wear. There was no scoring or scratching on the bearing surfaces of this engine.
The M54 is unknown about the mileage or if it ran, but the bores are good and it looks like the head and block are straight. The bearing surfaces on the crankshaft are good.
Everything is for sale so feel free to offer for any of those parts.
95 E34 553i6 LS TR6060 Project
93 E34 525iA Beater with no heaterVANOS kicked in yo!
bump
95 E34 553i6 LS TR6060 Project
93 E34 525iA Beater with no heaterVANOS kicked in yo!
How much for the m54b30 crank?
how much for the oil pan from the e34 M50?
What you wanting for the cylinder head?
Bookmarks