This is a 2006 E60 N52.
Due to ARS (Active Roll Stabilization) problems (leaking lines and seals, sensors codes etc.) I'd like to remove this Module from the VO so it wont give me error codes.
I did the modification with NCSexpert.
After that I generated the VO with the ARS module($229) removed for ISTA-P, but the change will not be reflected in ISTA-P giving me errors with "no communications" with the DME and else.
ISTA is asking to reconnect the module to finish testing, and then remove it from the VO.

I do not know how to Import the VO. Do I need something additional to Import the New VO to ISTA-P, like IBAC code or FSC?,
If so, how can I get the codes generated. This way the whole car can be reprogrammed by ISTA-P the right way.
Thanks for helping.