Mid pipe help

[B328iC]

OK so I finally broke down and got a cat back exhaust to go with the euro headers I purchased a while back.
I know someone, I think on this site, makes the mid pipes to mate them together. I don't remember who was making & selling them but if you can remember, or actually do it, I would like to know. Thanks for your help.

[XnWarden]

Ive never made one of these before, but I did fabricate a single 3 inch system from the headers to the back on my S52. It probably wouldn't be too hard, just a lot of measuring and cutting. Test fitting with card board cutouts helps a ton. Do you have access to a welder?

Sent from my VS987 using Tapatalk

[mslevin]

Something like this? https://www.ecstuning.com/b-superspr...onator/784342/

You could also take it to an exhaust shop and have them fab something if you don't need cats, may be the more cost effective solution.

[B328iC]

I'm looking at fabbing one up if need be but I don't have a welder. I thought there was someone here that has already done all the fabbing and was making them. Looking to save some time. If I do fab one up I'll probably keep the cats and add an x connector.