OK so I finally broke down and got a cat back exhaust to go with the euro headers I purchased a while back.
I know someone, I think on this site, makes the mid pipes to mate them together. I don't remember who was making & selling them but if you can remember, or actually do it, I would like to know. Thanks for your help.
Ive never made one of these before, but I did fabricate a single 3 inch system from the headers to the back on my S52. It probably wouldn't be too hard, just a lot of measuring and cutting. Test fitting with card board cutouts helps a ton. Do you have access to a welder?
Sent from my VS987 using Tapatalk
Something like this? https://www.ecstuning.com/b-superspr...onator/784342/
You could also take it to an exhaust shop and have them fab something if you don't need cats, may be the more cost effective solution.
1993 E36 325is
2003 E46 325iT
SpeedHunters feature: http://www.speedhunters.com/2018/04/...t-dtm-tribute/
APEX feature: https://www.apexraceparts.com/blog/m...-arc-8-wheels/
I'm looking at fabbing one up if need be but I don't have a welder. I thought there was someone here that has already done all the fabbing and was making them. Looking to save some time. If I do fab one up I'll probably keep the cats and add an x connector.
Bookmarks