Hey guys, as it says on the title I'm trying to make auto roll Down all 4 windows with the "aux" line of my alarm.
My car is a 96' 16i sedan. Aka love of my life 2
I have a module for the windows know how to wire it with the alarm but sending the signal to the windows is a problem.
As an example the GM IV module that i have comunicate with the window of the rear right door with 2 cables (pin 4 and pin 5).
To open the windows he sends positive signal in one wire and negative on the other. To close it he does the opposite.
At the start I was just thinking about using the same wire and putting some diodes on the oem and aftermarket wires so it doesn't confilct. BUT on the aftermarket I can do this as it'll only open the windows. The oem module otherwise I can't cause' my windows will never close as it won't allow the change of signals (+ n -).
How can I solve this?
I already found all the wires to make it work I just need the "how".
The aftermarket module gives positive and negative signal for each window.
Last edited by YuriASN; 12-21-2017 at 08:38 PM.
Yeah... I think I'll just give up.
Bookmarks