I found this on ebay with these The Warm Up Regulator Heating Coil can be removed and replaced when it breaks saving big bucks, he is in the Australia and has K and KE-Jetronic rebuilts items and parts for them. He has 21R,32R and 47R Ceramic Heating Coils. I ordered 2 of these 21 Ohms, about $12 each including shipping. My good,tested, and adjusted spare WUR-Bosch xxxx071 reads 20.2 ohms. 32R and 47R heating coils fit other WUR's- Control Pressure Regulators as well.
s-l500.jpgs-l501.jpgs-l502.jpg
https://www.ebay.com/itm/Warm-up-Reg...53.m1438.l2649
Adjusting the WUR and Hella Upgrade
https://www.bimmerforums.com/forum/s...sistance/page3
Your All Welcome, Merry Christmas in Advance
Randy
Last edited by 320iAman; 12-18-2017 at 11:51 AM.
Thank you Randy!
I was notified by Colin they have shipped .
Here is his web site
http://www.k-jet.biz/
Randy
Last edited by 320iAman; 12-18-2017 at 11:06 PM.
WUR Ceramic Resistors came in.
DSCI0174.JPGDSCI0175.JPGDSCI0176.JPG
Randy
Last edited by 320iAman; 12-27-2017 at 09:46 PM.
Put K-jet.biz (Colin)-Australia in Fuel Distributor rebuild in Faq's in case someone wants to buy rebuilt FD's and WUR's and not rebuild and install and be done as several like to do..
Randy
Looks like I need to replace my WUR. How big a job is it. It looks challenging. Any tips would be welcome.
Replacement is not difficult, it does take a while to remove items out of the way and remove the wur, its lines and so forth.
Randy
Theres 3 suppliers that rebuild WUR's
http://www.k-jet.biz/
http://www.fuelinjectioncorp.com/
http://www.cisflowtech.com/
Randy
Last edited by 320iAman; 01-16-2018 at 02:46 PM.
Bookmarks