So I just checked realoem and I believe number 5 is what I need PN 07129908103, Its the only one that seems close to the position and there is no stud shown in the ignition coil system on the other blow out diagram. I'm missing two which is rather obnoxious I just don't want to order the wrong hardware. Picture for reference
Ignition Stud.JPG
The valve cover is retained by a combination of #6 and #7.
#7 is used down the center of the valve cover, common to the coil ground straps.
The coils are attached on my 2 S52 and M52 are bolts, shown as #4 p/n 07119905400, in this image, image shows a nut, part is identified as a bolt in the listing.
http://www.realoem.com/bmw/enUS/show...diagId=12_1977
Sent from my iPhone using Tapatalk
Last edited by bluptgm3; 11-19-2017 at 10:56 PM.
So it's safe to assume the same studs retaining the beauty cover would be the same as the 12 that the ignition coils mount on? That's where my confusion was because the ignition coil blow out diagram only shows the nut that's used to secure the coil packs once they are on the studs
Sent from my SM-G955U using Tapatalk
My mistake I re read your post. The image just shows a nut but it is indeed the stud bolt
Last edited by AlpineM3OldAsMe; 11-19-2017 at 11:00 PM.
Bookmarks