Cool, I'd like to see them
Randy
Here are my BC coilovers with swift springs upgrade.
IMG_4950.jpgIMG_4951.jpgIMG_4954.jpgIMG_4956.jpg
Nice, I see how the backs fit, how does the fronts fit ?
Randy
Got it ,weld it on. Then fill with oil or use air pocket for cooling ?
Randy
Technically you are welding to the knuckle, but your using the strut as a guide to make sure its at the correct angle.
Found this image online of a set installed.
suspension002.jpg
Last edited by pofo; 12-11-2017 at 10:03 PM.
Air cooled or Oil cooled dampner or Strut Insert ?
Randy
Last edited by 320iAman; 12-11-2017 at 10:15 PM.
pofo, personally i don't care what you do, but if all you want is to impress your friends with shiny then you did good. however, you did say 'track time' and these are not track worthy.
Tom D
77 e21 - m42
88 e30m3
04 330 dinan3
84 r1000rt
02 r1150rs
all of them gray
14 f800gsa - red headed stepchild!
You also miss the part that I said I'll be upgrading to a custom set up when the time comes. But my current factory suspension was cut and I would like it a little higher and the shocks are far past blown. And personal I dont belive that the skinny little 48 mm shock for the coilover from CG is worth 2k shipped. It's was a cheaper temporary alternative and will allow me to invest money in more things I enjoy.
Last edited by pofo; 12-12-2017 at 04:00 PM.
yea its a bitch, but going fast cost money!
building coilovers are not cheap, but for the same money as those bc's you could be running a high quality koni adjustable suspension....... although without the bling.
Tom D
77 e21 - m42
88 e30m3
04 330 dinan3
84 r1000rt
02 r1150rs
all of them gray
14 f800gsa - red headed stepchild!
Bookmarks