260.0.1270.90 is on the side of the 'eta' trans
ii) shifter mounting about the output flange is only 2xM10 holes for the 84,85,86 style plate mount shifter
iii) deep bellhousing : Slave cylinder mounting flange = 6 7/8
iv) 2 drilled holes for crank position sensors
v) smaller output flange
Picked up from a conversion - less than 100K on odo...
$300 or OBO ...sitting in my garage in the way .
https://dallas.craigslist.org/ndf/pt...366854915.html
PM at vinnie86 or vince3@tx.r.com
Bookmarks