Accelerator pedal spring question

[TITE3NBIGD]

So, I replaced my throttle cable along and the pedal bushings(they had broken, I assume just from being in there that long) and now I don't remember how the spring hooks onto the pedal shaft and the hook at the other end. One end of the spring has the long hook and I think hooks onto the front of the shaft(on the side facing the driver), but the short hook(other end of spring) I am not sure about. Should have taken picture before I took apart. I have the realoem diagram, but it only shows the parts apart.
Anyone want to take a picture of the actual spring in place to show how it hooks up to the shaft. Would be much appreciated.

[Pelican Parts]

Hello - take a look at the link below to an earlier thread where this is discussed. There are steps listed as well. Hope this helps you a bit, best of luck!

https://www.bimmerforums.com/forum/s...robably-broken

[TITE3NBIGD]

Hello - take a look at the link below to an earlier thread where this is discussed. There are steps listed as well. Hope this helps you a bit, best of luck!

https://www.bimmerforums.com/forum/s...robably-broken

figured it out. thanks