NorCal pickup: Built frankenstein motor, M52 block, S52 head, CP-Carillo, Supertech

[///dean]

Engine has been sold..thanks

[///dean]

Bump with head specs

[///dean]

Still available, to the PM's asking to part out, I am not doing so at the time.

[///dean]

Still availabe

[///dean]

Price drop

[///dean]

Still available

[m3mods]

Hate to be that guy but any thoughts on parting yet?

[///dean]

Hate to be that guy but any thoughts on parting yet?

No, no plans or motivation. Looking for the simplest route.

Price significantly lowered

[///dean]

Bump...price drop

[ultimachi]

If you were going to turbo this how much power can this build withstand safely? I’m just looking for something that can handle 400hp or so safely. But I see it was built to stock spec.


Sent from my iPhone using Tapatalk

[pbonsalb]

This is a very nice motor. Could probably do 900 rwhp on E85 or race gas. On pump gas, much less due to the stock compression — under 400 rwhp on 91 and that at best on 93. You would have to add a spacer and recut the head to get rid of the cut from the cutring gasket that is in there, which is a shame since it was just redone, but doable unless this head is already cut to the limit. Then you might do 550 on 91 and 650 on 93.