I ve damaged 2 spark plug boots, they can't be re-crimped, NGK has a boot, PART #8386 for a 14MM plug, with 5K ohm resistance...
This resistance is critical correct? Sorry for the urgency i'm trying to order before a deadline today.....
original is
spark plug ends 5.0+/- 10% kohm
shielded plugs 1.0 +/- 20% kohm
spark plug wires 0 ohm (approx.)
so it should fit Ohm-wise, but no idea how it is connected to the wire https://www.ngk.com/product.aspx?zpid=20084
Last edited by shogun; 09-13-2017 at 07:09 PM.
Shogun tricks and tips for the E32 series are HERE!
They screw on, then a seal slides down and locks onto the holder...they are a bit shorter, but will get me through until I order wires to match the others, there are only a few more weeks of driving left up here, i'm trying to get it running for the weekend...
sounds good, let us know how it works and make some pics how to assemble.
Edit: found a youtube DIY for a similar NGK boot https://www.youtube.com/watch?v=UUcfzpM8aa8
Last edited by shogun; 09-14-2017 at 02:58 AM.
Shogun tricks and tips for the E32 series are HERE!
fail....ordered the wrong boots, the 8386 goes onto a plug with the threaded tip, not the snap stud...on the NGK the stud dos not unscrew....trying to order the correct boot now....
Last edited by Sundancer; 09-15-2017 at 05:03 PM.
Will send out to you within 1 hour from now by EMS 3 ignition leads with lengths 85cm, 77cm, 60cm, should arrive within approx. 4 days.
based on this pic http://www.meeknet.co.uk/E32/V12_Distributor_Leads.htm
Last edited by shogun; 09-16-2017 at 08:19 PM.
Shogun tricks and tips for the E32 series are HERE!
I changed one plug to test the fit of the boots, fail...the inner seal is too large to fit inside the M70 recess...soooooo quick email to shogun, he had wires on the way within 30 minutes: )
Bookmarks