Hi guys, waiting on my ls1/t56 to arrive next week. Meanwhile trying to get some things prepped so that the swap goes quick. Does anybody know the driveshaft length for cxracing swap motor/trans mounts. I have ls1/t56 out of 2002 camaro, its going into 1994 318s. Thanks in advance.
Last edited by Daniils; 08-09-2017 at 07:26 PM.
i run an older Vorshlag DS i got used on here with a Strange yoke and the JTR 4 bolt adapter.
not sure on the exact length.
i'll try to get under there this week and report back.
always trying to make it lighter and faster
^^former build: http://www.bimmerforums.com/forum/sh...-neglected-M3/
current build: http://forums.pelicanparts.com/porsc...car-build.html
instant grams: doktor_b
Mine is from Coleman racing, 44.5" long, 3" aluminum driveshaft. Part number is 16621. They're $275 shipped. You will have to hammer on your floor in a few spots near the e-brake cables.
It's using a JTR flange on one end and a Spicer 2-3-6081X yoke at the transmission.
Last edited by squashman702; 08-25-2017 at 09:41 AM.
Instergrams: @davemakepictar
^^ I have the coleman racing but steel, 2.5" diameter, $170 shipped to my door I believe. 44.5" long with JTR adapter and I believe a 5.5" yoke, allows for 0.5"-0.75" of play.
coleman racing have a 3" 4130 option"
Bookmarks