so the circuit board is part of the tail light and i have to buy a new tail list lens/ circuit board ?
there is power to the circuit board but there
is bad contact to the lamp holder.
i replaced the lamp holder same thing.
anyone else run into this ?
The circuit board can have some light oxide, you can use some very fine sandpaper to clean the contact area.
Attn. NEWBIES: Use the search feature, 98% has already been discussed.
Click the search button, select "search single content type", select the "e36 sub forum" specifically, try the "search titles" then try the "search entire posts".
One of my lights has a hole in the circuit board where the lamp holder contact meets. I think this is a common issue. I've tried to fill the hole with solder and wrap in foil. No brake light warning messages so far.
I also had an area where the board was bad and was able to fill with solder.
Attn. NEWBIES: Use the search feature, 98% has already been discussed.
Click the search button, select "search single content type", select the "e36 sub forum" specifically, try the "search titles" then try the "search entire posts".
Bookmarks