Help codding m35090 chip

[Dakes12]

I cannot change the subject of topic. It's about m35080 chip.. Sorry.

I got my car with a motometer cluster (replaced one. original was bosch) and i wanted to replace it with a bosch one. I don't have background light, abs light, etc operationally because of the difference between them.
Finally.
I bought a used bosch cluster, i got a new m35080( chip and i replaced the old m35080 chip with the new blank one.
Now is the problem. I replaced the cluster and the bosch one with blank chip shows me on the display in left PPPPP.
I was trying to recode it with pasoft. I cannot set the VIN. Is asking for the factory defaults. When i press the button with factory defaults is showing me a error.
I cannot get the bosch cluster working.
PLEASE HELP ME TO CODE IT and to make it working. I already lost few hours trying to set vin and mileage with PaSoft.

If anyone have time to explain me how to recode it with pa soft would be more than awesome !
Thank you in advance.

[328 Power 04]

You should use NCSExpert to write the coding data that you extract from EWS or LCM.

Can't you just transfer the m35080 from old cluster to new?

[Dakes12]

I bought the car with a motometer cluster. The oem one was Bosch. So i didn't had the m35080 chip..
I bought a used Bosch cluster and a new m35080 chip to code it. I soldered it but I cannot change the vin and even to code the km.
I think that I need to write almost everything about the car on that chip. Honestly I don't know how to do it..
If I will write from ews to m35080 chip, do you think that it will make my cluster to work? Can you give me a diy to do that? Thanks !!!

Can I write coding data from ews to ike with pa soft ? It's pretty easy for me.


Sent from my iPhone using Tapatalk