New to the site and figured I'd post a little about my build . I'm almost finished my Z3 with a 6.0 LQ4. Engine has a set of 823's LS3 heads and intake. Brian Tooley stage 3 turbo cam and springs with harden push rods! All Arp bolts of course. Transmission is a tr6060 6 speed and we made custom mounts our selfs for the engine and transmission. 80mm billet wheel turbo with T6 flange. Hydro dipped valve covers timing cover and intake. Car is going to still keep A/C. I'd post picks but I'm not seeing a way to do so.
Sorry I'm not sure how to do that. I'll try and figure it out.
Hopefully I did this right!
- - - Updated - - -
https://flic.kr/p/UECeJb
Photos look good
Looks mint. Did you repaint engine bay? Or did it just clean up nice.
Last edited by fallguy; 06-20-2017 at 05:35 PM.
It just cleaned up that nice. The only thing left is the hot and cold side.
- - - Updated - - -
Thank you I've took a while to get this thing where it is!
Do you have pics of the turbo mounted? Is it centre mounted? Do you have enough room in there for it?
Sent from my E6553 using Tapatalk
Just dropped it off to have a hot and cold side done.
What are your plans for the diff mount/trunk floor?
Just starting to research that part and trying to see what I wanna do. Any suggestions would be great.
Sent from my iPhone using Tapatalk
This makes me want to start mine. I'm too lazy to drop my block off at the machine shop. Haha.
Looking for a set of wheels as well. Any suggestions
Sent from my iPhone using Tapatalk
Is that a 6cly wide body car?
Apex has some nice wheels, that's what lots of guys run. How wide do you want to go?
Man, that thing is going to be a beast! The paint on the VC, intake and front cover was screwing with my eyes. I couldn''t focus on it. Sux getting old!
keep us posted.
https://www.bimmerforums.com/forum/s...to-me-Z3-coupe
Mid way down you will see my wheel and tire specs.
This is what I wanted to put on my car. They don't offer a 5 on 120 tho.
Bookmarks