I've got shrinkage issues with door seals

[JMCLuimni]

The door seals on my 740iL have all shrunk over time.
Is there a way to restore their length or am I in the market for a replacement set?
With that being said, if someone has a full set of front and rear door seals would you send me a PM with a price please?
Thanks

[unity]

I think I found the suggestion here, but what I did was cut them. At the bottom there is a seam where the two ends meet. I cut there. Then I just pulled most of it off and re-attached. This left a gat at the bottom where I put some fuel hose to close the gap. I cut eh hose down its length to split into two.

[shogun]

DIY Cheap Shrunken Door Weatherstripping Seal Fix https://www.bimmerforums.com/forum/s...ghlight=shogun

[youngbimmer]

As unity said, I had shrinkage on my door seals. I had a spare seal I ripped from a parts car. Cut the door seal where it sits under the plastic foot cover, reseat the door seal, graft in a piece, then I spray flex seal on the joint. My driver door was a different story, a lot of the door seal was ripped so I had to graft a bigger piece and it wasn't possible to hide it due to the curvature of the seal but it works for utilitarian purposes. New door seals are around 85$ a door if I recal correctly.

[JMCLuimni]

Thanks guys.