Does anyone have experience with these?
http://www.rogueengineering.com/Rogu...unts_p_78.html
Thanks!
"Speed's just a question of money. How fast you 'wanna go?"
PM me for E36 engine swap books and BMW ETMs! NOW SHIPPING!!!
Bimmerworld sells a house version as well. And consider the Vorshlag red poly mounts -- I have been running them for years on my E36M3. Have also run Bimmerworld copy of Group N and they were fine. Tried Rogue lower/harder version of Group N on my E90M3 and they added some NVH at idle which I did not like but think they may have been ok with a higher idle speed.
I was planning/saving for "real" group N mounts but the cost is just stupid for what it is. I'm sure one of the OEMs makes them for BMW.
I like the stock look. A bit more vibration won't kill me. I will look into the other options as well but I don't want red poly- I want a stock look.
Try Bimmerworld Group N copies.. They look stock.
Just checked bimmerworld and they are out of stock. They're supposed to email me when they are back in stock.
They do look good.
They're ok for me on a street car. More NVH at idle (stock idle) though. If you raise the idle maybe 200-300 rpm the roughness goes away. I'm also running the Rogue trans mounts. For less NVH you can also consider stock motor mounts and the e21 stock trans mounts with cups.
Bookmarks