Member
Hi, I was changing out the speed sensor in my 02 x5. .. the black end of the sensor was melted into the hub assembly? (Just bought the BMW). I can get it out.. however I feel like I'm going to damage what that end is plugged into... I'm not sure if it will or not and or what part I would have to replace if it is damaged. Any help would be greatly appreciated! Please note it is the black end.. not the blue connector
Wagon meister :)
BMW Tech Expert
Welcome to the Forum!
As far as I know, there shouldn't be a connector directly on the sensor where it goes into the hub. There should be about a foot or two worth of cable that takes the wire up to the body where it connects, and this applies to front and back.
Darin
Current:
16 220i Active Tourer Platinsilver MET (C08)/Dakota Black (PDSW), P7ACA, P7LDA, P7LHA, P9BDA, 6sp Manual - Wife's new toy!
05 325it Electric Red(438)/Gray(N6TT) ZCW, ZSP 5sp Manual Back set cover, trunk mat, Euro Infra-Rot front windshield, and mud flaps! Mr. Wagon My new Winter car.
05 M3 Imolarot II(405)/Gray(N5TT) ZCW, ZPP 6sp Manual C.F. Lip, CSL diffuser, SSK, Euro Infra-Rot front windshield and a trunk liner! Mr. Go_Fast Stored for the Winter
Past:
95 318is Montreal Blue Met (297)/Beige(K1SN) RIP, killed by an Idiot.
84 M535i gray market Burgandy Rot Met/Black Leather Lowered by Intrax on bilies, poly everywhere, B&B cat back system, K&N, and a hitch! Da Beast - Still running w/400k+!
91 316i euro Tizianrot/Gray cloth - E-36 w/M-40 RIP, but great on gas! Best was 38 MPG
82 528i euro Saphire Blue Met/Blue Leather RIP
79 525 euro Green/Green RIP
79 318 Silver/Black - The first one that got it all started
M-Flight Member
Posting Permissions
Reply With Quote
Bookmarks