Hi, I was changing out the speed sensor in my 02 x5. .. the black end of the sensor was melted into the hub assembly? (Just bought the BMW). I can get it out.. however I feel like I'm going to damage what that end is plugged into... I'm not sure if it will or not and or what part I would have to replace if it is damaged. Any help would be greatly appreciated! Please note it is the black end.. not the blue connector
Welcome to the Forum!
As far as I know, there shouldn't be a connector directly on the sensor where it goes into the hub. There should be about a foot or two worth of cable that takes the wire up to the body where it connects, and this applies to front and back.
Darin
Current:
16 220i Active Tourer Platinsilver MET (C08)/Dakota Black (PDSW), P7ACA, P7LDA, P7LHA, P9BDA, 6sp Manual - Wife's new toy!
05 325it Electric Red(438)/Gray(N6TT) ZCW, ZSP 5sp Manual Back set cover, trunk mat, Euro Infra-Rot front windshield, and mud flaps! Mr. Wagon My new Winter car.
05 M3 Imolarot II(405)/Gray(N5TT) ZCW, ZPP 6sp Manual C.F. Lip, CSL diffuser, SSK, Euro Infra-Rot front windshield and a trunk liner! Mr. Go_Fast Stored for the Winter
Past:
95 318is Montreal Blue Met (297)/Beige(K1SN) RIP, killed by an Idiot.
84 M535i gray market Burgandy Rot Met/Black Leather Lowered by Intrax on bilies, poly everywhere, B&B cat back system, K&N, and a hitch! Da Beast - Still running w/400k+!
91 316i euro Tizianrot/Gray cloth - E-36 w/M-40 RIP, but great on gas! Best was 38 MPG
82 528i euro Saphire Blue Met/Blue Leather RIP
79 525 euro Green/Green RIP
79 318 Silver/Black - The first one that got it all started
M-Flight Member
Bookmarks