As I tried assembling camber plates onto coilovers the other day, I found out that the complete set up was too tall to allow me to thread the top nut on.
The springs are 2.25" and the shaft is 14mm. Does anyone know where I can get the proper spring hats/perches or bushings required to make my set up work? The only place that I seemed to be able to find some was on turnermotorsports's site, but the parts are unavailable until June.
-Don
Ground Control should have what you need.
Thanks. Couldn't find anything on their site easily, so I sent them an e-mail. Never knew trying to find something like these parts would be so hard.
Call them for a faster response.
Yes, call them. They general provide fantastic service.
Did you use a spring compressor before trying to bolt top nut on, otherwise, you'll have the problem you're experiencing?
Bookmarks