Z3 coupe L33 twin 6262

[Brentinpdx]

Can I ask a question? It sounds like there’s been salt water intrusion into the crank case at some point since the last overhaul. If you flush it can you send video and if there’s a good amount of milky water? Thx

[fallguy]

How do you have your heater core lines ran?

I have to double check. But I have it feeding into the factory expansion tank. Then into the control valve.... into the heater core... back to the water pump. I also have the steam line from the top of the engine feeding into the small line on the tank.

- - - Updated - - -

Can I ask a question? It sounds like there’s been salt water intrusion into the crank case at some point since the last overhaul. If you flush it can you send video and if there’s a good amount of milky water? Thx

Not picking up what you are putting down. Lol.

[motorV8ed]

its not going too bad, was out on the road a bit before i put it away for winter in December. Was having some cooling issues added a fan shroud and a 160deg stat, it seems to be helping before it would get to 220deg now it seems to be 190ish.

I'm going to add another muffler in the tunnel to tone it down a bit, the single 4" is a bit much with just one straight thru vibrant muffler.

https://youtu.be/974UGjUj7gY

https://youtu.be/yUIldGFrins

Great to see it on the road! Congrats.

[fallguy]

little side project. Made a fixture to locate the BMW and ford 8.8 from the diff outputs. Still have to modify the opening for the swing of a 1350 joint. I’ll probably put it in next winter and modify the trunk floor and get some custom shafts made with 930 joints.


CAE47BA0-5701-4CD8-8766-DFE6A9A4CF79.jpgE33DB6A3-7854-4844-82CC-B1AF2512C0D7.jpg

[fallguy]

Also put another muffler in the tunnel to tone it down a bit, the single 4” exhaust is a bit rowdy. Used a aero 4040XL muffler

https://youtu.be/v7nwODndRYo