Yeah I can make em. Let me know if a few people need them. Not worth it to cut just one.
I think I have a extra one. I just checked and I do have one. Send me a pm if you want it
Last edited by z3forlife; 05-29-2018 at 07:33 AM.
If you're planning on making more, I'd like to purchase one. I definitely need to reinforce mine before it gets too bad.
I bought one through ebay and it did the trick for my sagging glovebox. Beware on install, though.. Even though I was trying to work the box out slowly, one of the tabs on the left side that match up the console snapped off. I just reconnected the remaining screw/tab and seems secure enough, but I had to put the other screw in with a little glue, then replace the screw cover for the original look.
Are you still making these? How can I get one?
Fixable...
20180519_150410.jpg
Nathan in Denver
1999 M Roadster, VFE V3 S/C, Randy Forbes Reinforced, Hardtop, H&R/Bilstein, Apex PS-7, Supersprint
1999 Z3 2.8 Coupe, Headers, 3.46, Manual Swap, H&R/Koni, M Geometry/Brakes, M54B30 Manifold, Style 42
How do I get one?
If you are making them again, I would like one as well.
Thanks.
I’d like one as well
I woud also take one.
Mike
Put me on the list
If you're taking orders, I'd like one as well!!!
Hello, I will take one as well
If you're taking orders, I will take one.
Does anyone know if this member is still producing this product? Have sent PM to member, but no reply........maybe no longer on the forum??
I'm not the guy but I have 1 extra. It comes with 3 long screws and nuts. 1st PM gets it $20 shipped
I'm working from my phone right now , and i can't pm you, but would certainly appreciate it if no one has spoken for it already.
You're first it yours
A quick review of the OP's profile shows that they have been inactive for a couple of years.
The user at the top of this page has been making small batches. Vikrampatel86
Still making this item? What's the going price now? Thanks!
I need a new brace if you are still making them. If so, let me know the cost.
Bookmarks