ECS Tuning sells a kit with all the needed parts. I don't remember the part # but it's on their site.
Check out my current build pics here
Hi, I know you said the bracket wasn't in the picture but I just can't picture where it would go, I've just replaced the pump on mine and there wasn't a bracket present, just the two nuts and bolts that go through the bumper bar and the screw through the bottom of the bottle/bumper. Do you have any pictures? Thank you
Has anyone checked to see if an E90 washer reservoir would fit in the fender of an E36?
Do you have the bracket? How does it fit to the tank and then the car, on mine the tank is fastened on the bumper cross member and then again through the button but no other brackets?
That's the coolant reservoir, not the washer fluid reservoir.
There is no need to plug the headlight washer pump if you don't have it. There are two versions of the container, for with and without headlight washers.
On my SMG car, the bracket is not installed. As mentiond, nut/bolts (2x) through bumper bar and screw/body nut for the bottom mount.
No idea when and how that bracket is used, although that open end 'fork' goes around that funny looking 'button' that is on top of the reservoir.
Not my pic:
And it could be fitted incorretly as that other 'floating' mount looks out of place.
1998 BMW M3 3.2 Cabrio Alpinweiί III on Schwarz German spec 1 of 12
SMG SRA PDC AUC OBC GSM HK UURS IHKA FGR MFL
IG: https://www.instagram.com/iflok/
The euro washer tank shouldnt interfere with the hot pipe if you have a bend right at the intercooler inlet. The washer tank is C shaped and sits around the RH fog light outboard of the RH brake duct.
I have one. It gives me a lots of room up top for a big cone filter.
Last edited by chikinhed; 10-03-2018 at 09:34 PM.
To be clear, the bracket that's not used on your SMG car is part #61662228398, correct?
For those who have installed this tank in US cars, was bracket #61662228398 needed?
And I assume omitting the small strainer, part #61681386307, that's NLA is not critical?
Thanks.
Yes, that bracket is not used on my M3 SMG. I have a hard time visualizing how it would fit.
The strainer is just a filter/siff. You don’t need it. Though I’m happy I ordered two some time ago. I usually do that now as more and more parts become NLA out of the blue.
And this strainer actually fits. The strainer on the non-SMG bottles are held in with these super thin tabs that always break after quick while.
1998 BMW M3 3.2 Cabrio Alpinweiί III on Schwarz German spec 1 of 12
SMG SRA PDC AUC OBC GSM HK UURS IHKA FGR MFL
IG: https://www.instagram.com/iflok/
Bookmarks