Just so I understand properly, the assembly itself is stuck inside the Glass and won't drop out?
Darin
Current:
16 220i Active Tourer Platinsilver MET (C08)/Dakota Black (PDSW), P7ACA, P7LDA, P7LHA, P9BDA, 6sp Manual - Wife's new toy!
05 325it Electric Red(438)/Gray(N6TT) ZCW, ZSP 5sp Manual Back set cover, trunk mat, Euro Infra-Rot front windshield, and mud flaps! Mr. Wagon My new Winter car.
05 M3 Imolarot II(405)/Gray(N5TT) ZCW, ZPP 6sp Manual C.F. Lip, CSL diffuser, SSK, Euro Infra-Rot front windshield and a trunk liner! Mr. Go_Fast Stored for the Winter
Past:
95 318is Montreal Blue Met (297)/Beige(K1SN) RIP, killed by an Idiot.
84 M535i gray market Burgandy Rot Met/Black Leather Lowered by Intrax on bilies, poly everywhere, B&B cat back system, K&N, and a hitch! Da Beast - Still running w/400k+!
91 316i euro Tizianrot/Gray cloth - E-36 w/M-40 RIP, but great on gas! Best was 38 MPG
82 528i euro Saphire Blue Met/Blue Leather RIP
79 525 euro Green/Green RIP
79 318 Silver/Black - The first one that got it all started
M-Flight Member
I don’t know if this will help, but, the shaft of mine wasn’t so stuck in the glass as it was fused to the switch housing. I had to use a sharp pick and utility blades to scrape around the area where the shaft protruded through the housing. I also soaked in vinegar to help devolve some of the calcification. I addition, I used plenty of penetrating oil and gradually was able to wiggle it apart. I replaced the switch housing with new as well.
Bookmarks