$170 shipped via USPS Priority Mail
I'm now offering the best e36 secondary air pump simulator in a plug & play version that installs in 10 minutes with no wire cutting/splicing and no permanent modifications to your engine harness or O2 wiring!
Just unplug the secondary air pump, connect the SAP sim to its power connector then unplug both pre-cat O2 sensors and connect the SAP sim connectors to the O2 sensors connectors and engine harness O2 connectors.
These are higher quality than the other SAP sims out there:
-electronics sealed in epoxy for protection against moisture/vibration
-high-temperature, color-coded GXL wire cut to correct length and covered in wire loom
-mounting tab for installation
-individually tested
-money back guarantee: if you install properly on a m52 and have any issues you can return it for a full refund within 2 weeks of purchase
Also available without the o2 connectors (requires splicing) for $70 shipped - http://forums.bimmerforums.com/forum....php?t=1864267
Last edited by gpeterson; 04-04-2016 at 09:51 AM.
bump
Sorry I am a noob, what would deleting this air pump imporove or make easier/better? Does this have to do with the m50 manifold swap etc?
Hi g. I would like to know how to get a hold of one. Also what do you do with return valve on the header?
How do I PM you?
Last edited by thomas1bmw; 09-02-2012 at 11:27 PM. Reason: Automerged Doublepost
How can I get you my email. My sap went out this last week and it is driving nuts. Kput, Kput Kput. I just installed all 4 O2 sensors last weekend
More info and email address available at http://e36-electronic.com/.
Last edited by gpeterson; 09-02-2012 at 11:47 PM.
G, I guess since I am new I need 7 posts in order to PM
Thanks G. I will go the http link.
Last edited by thomas1bmw; 09-02-2012 at 11:46 PM. Reason: Automerged Doublepost
Yes, all m52.
Last edited by gpeterson; 09-05-2012 at 08:40 AM.
Only 1 more plug & play ready to ship, may be 2 weeks before I have more.
This is getting tempting. I need a place to put my catch can.
97 BMW M3 (s52b32) - VF-Supercharger kit ( Vortech V2-SQ supercharger, 32 pound injectors, VF tuning ), VDO/LeatherZ Gauge Kit (Oil Temp, Oil Pressure, and Boost), UUC Motorwerks RSC36 Exhaust, Stainless Steel 6-2 Exhaust Headers, Bilstein Sports, Rear Adjustable Camber bushings, Wheel Spacers 10mm in front 25mm in back, Uprated Clutch, UUC Shift Knob, Short Shifter and Clutch Stop, Cross Brace, Mason Engineering front strut bar, Contour Wheels, Euro Ellipsoid (Angel Eyes) HID Headlights, braided steel brake lines, aluminum thermostat housing, mishimoto aluminum radiator and silicone hoses and a partridge in a pear tree
I also have a handful of the cheaper ($95) non-plug & play ready to ship as well. Those are pretty much always ready to go.
Thanks for the quick response Garry...can't wait to install this!
Just got more connectors and have a few more plug & play sims ready to ship.
Also available without the o2 connectors (requires splicing) for $95 shipped - http://forums.bimmerforums.com/forum....php?t=1864267
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
Instruction manual for plug & play SAP sim is now available, check out http://e36-electronic.com/Documents/...ionPNPV1.1.pdf to see how easy installation is.
Last edited by gpeterson; 09-26-2012 at 01:45 PM. Reason: Automerged Doublepost
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
Here are before & after installation pictures of the O2 connectors. Nice & clean, even though it gets hidden by the fuel rail cover. (vehicle shown has M50 manifold)
Last edited by gpeterson; 09-29-2012 at 12:14 PM.
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
Very tidy.
97 BMW M3 (s52b32) - VF-Supercharger kit ( Vortech V2-SQ supercharger, 32 pound injectors, VF tuning ), VDO/LeatherZ Gauge Kit (Oil Temp, Oil Pressure, and Boost), UUC Motorwerks RSC36 Exhaust, Stainless Steel 6-2 Exhaust Headers, Bilstein Sports, Rear Adjustable Camber bushings, Wheel Spacers 10mm in front 25mm in back, Uprated Clutch, UUC Shift Knob, Short Shifter and Clutch Stop, Cross Brace, Mason Engineering front strut bar, Contour Wheels, Euro Ellipsoid (Angel Eyes) HID Headlights, braided steel brake lines, aluminum thermostat housing, mishimoto aluminum radiator and silicone hoses and a partridge in a pear tree
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
Quick question, with this installed and cats deleted with o2 sensor simulators post cat, does that mean that there will be no o2 sensors in the exhaust at all ? or does this go in addition to the pre cat o2 sensors ?
2002 325i Silver Metallic Sedan/Manual - Modding Every Day
- Street Stars Motorsports -
- Bimmerworld Dealer
- UUC Dealer
Pre-cat sensors stay, this just sends a different signal to the DME during cold start when the SAP should be running.Originally Posted by Worstenemy453
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
OK. I believe i PMed you.
2002 325i Silver Metallic Sedan/Manual - Modding Every Day
- Street Stars Motorsports -
- Bimmerworld Dealer
- UUC Dealer
Don't see a pm from you...Originally Posted by Worstenemy453
S54 swap DME flashing - $100
S54 swap CAN interface board (for proper A/C & check engine light) - $275
e36 SAP sim/secondary air pump simulator: $75 - standard or $170 - plug & play
e36 post-cat O2 sims: $115 shipped, plug & play
Bookmarks