I was changing my pads this morning, when i noticed this hanging by a wire on the driver's side in front of the fender liner. Can anyone tell me what it is?
1993 Mauritius Blau 325i
Turner Motorsport Chip - BavAuto Intake - Ansa Sport Exhaust - Fan Delete - Akebono Euro Ceramic Pads - MB Quart - Panasonic
///M Rear Bumper, Mirrors, Door Moldings, Shift Knob - OEM Clears F/R - 55w 3000k HIDs - 17x8 Style-5s - 215/40 BFG G-Force Sport
H&R Sport Cup-Kit - Powerflex FCAB & RTAB - Ground Control RSMs - 96+ M3 Strut Plates - Sparco Strut Tower Brace - UUC Tranny Mounts/Enforcers & Clutch Stop
outside air temp
328i C
^^Thanks. Where is it supposed to be mounted?
1993 Mauritius Blau 325i
Turner Motorsport Chip - BavAuto Intake - Ansa Sport Exhaust - Fan Delete - Akebono Euro Ceramic Pads - MB Quart - Panasonic
///M Rear Bumper, Mirrors, Door Moldings, Shift Knob - OEM Clears F/R - 55w 3000k HIDs - 17x8 Style-5s - 215/40 BFG G-Force Sport
H&R Sport Cup-Kit - Powerflex FCAB & RTAB - Ground Control RSMs - 96+ M3 Strut Plates - Sparco Strut Tower Brace - UUC Tranny Mounts/Enforcers & Clutch Stop
or brakeduct, if you are still not sure...
next to the fog, on the left, as you're looking at the car (i think)
fits in a little hole on the top. (or side)
it will be blindingly obvious when you take a look.
Giftschrank Projekt
opps, as above, on the drivers side...
Giftschrank Projekt
There's a hole in the air duct that it sorta snaps into.. You should be able to see if if you look inside the duct from the front, pretty sure the hole it on the top side..
-Qaz
02 330i
i see a red "x" , saw that when i signed the loan papers to my car.
Bookmarks