4.8mm thick~
1"o.d.
.75" i.d.
If you have searched what people run for thickness you'll know its generally 5mm. These being 4.8mm they have room too run the factory crush washer. will fit e30/e36
$15 per set shipped usps.
big drifties bump
This is going to sound stupid, but where do these spacers go?
The spacers go in between the inner tie rod and steering rack and gives the steering rack more angle by furthering the racks push/pull. It is a good entry level mod to do for drifters. It will not give you quicker steering, just more angle.
You will have to adjust your outer tie rods inward the thickness of the spacer after installation for proper alignment.
what are these used for?
Increased steering angle, much needed for drifting or if one wants to be able to make tighter U turns
yo looking for some 6 or 7mm spacers asap don't suppose you have anything larger than the 4.8 do you?
I would like a set, how do I purchase them?
Hey,
New to BF so no PM preveliges...
Can you email me at:
spaquet (at) rprhydro (dot) com.
I want to get a set of spacers, obviously...
ttt email sent
I'll take a set. PM me your paypal addy
Bookmarks