My blower motor works fine, but when you put it on 3 or 4 power it rattles, on 4 it is so bad it sounds like my car is going to explode. Id like to fix this issue for faster heat delivery in the cold. Anyone know whats wrong?
Ive opened up twice and checked to make sure their wasnt like a rat living in their and all the part around it are fine, not loose at all. I dont get where this rattleing is comming from.
Please help, thanks.
Model: 1987 BMW 325ic
One or more of the fins have come loose on the fan cage. When you turn it up, they deflect out far enough to interfere. Fix is to replace the fan. Alternately, you can swap cages. It depends on your mechanical aptitude.
"Howdy, Folks!"
1986 Delphin 528e - Roof rack equipped lumber hauler.
1989 Zinnoberrot 325iX Sedan - I miss this car. (Deceased)
1998 Avus Blau 328iC - Someone else's project now
2008 Platinum-Beige X3 3.0si - Current project
2012 Alpine White X3 xDrive35i - My new snowmobile.
2020 Estoril Blue 440i xDrive cabrio - This car is a blast to drive.
maybe it's the bearing. take the cowling and the plastic cover off but dont undo the retaining clip and turn the fan on. c if you can track iy down that way.
Took the front cover off and on 3 setting its fine but on 4 it still rattles. Blower motor was just replaced, its from a low miles e30.
And its too late tonight, gets dark at 4 in seattle, will work on it tomarrow.
Im a newb mechanically. And are the fins your talking about the things that let the air into the blower cage? The flaps on the side?
Last edited by WSchnitz; 12-07-2011 at 07:42 PM. Reason: Automerged Doublepost
They are the big plastic things that look like hamster wheels. As you just installed it, I'm thinking maybe the fan wasn't seated correctly.
"Howdy, Folks!"
1986 Delphin 528e - Roof rack equipped lumber hauler.
1989 Zinnoberrot 325iX Sedan - I miss this car. (Deceased)
1998 Avus Blau 328iC - Someone else's project now
2008 Platinum-Beige X3 3.0si - Current project
2012 Alpine White X3 xDrive35i - My new snowmobile.
2020 Estoril Blue 440i xDrive cabrio - This car is a blast to drive.
Kay, i put the same way back in, but tomarrow ill make sure that the blades are not rubbing anything.
i just did mine yesterday also and had to move it around a little to get it seated right. do you have the retaing clip reinstalled corectly?
its most likely the bearing unless it is not installed correct. just did mine last night too on one of my e30s, also i had replaced it last year and it broke again this year. not that hard to do. easier then any other bmw
The bushing (bearing) is usually more of a squealing sound. Interference with the cage usually sounds more like a rattle.
"Howdy, Folks!"
1986 Delphin 528e - Roof rack equipped lumber hauler.
1989 Zinnoberrot 325iX Sedan - I miss this car. (Deceased)
1998 Avus Blau 328iC - Someone else's project now
2008 Platinum-Beige X3 3.0si - Current project
2012 Alpine White X3 xDrive35i - My new snowmobile.
2020 Estoril Blue 440i xDrive cabrio - This car is a blast to drive.
Bookmarks