I just got my peake tool today and used it, i love it. Easy to use, but at first it threw me these codes:

32:ignition coil cyl #3
35:misfire cyl #4
36:misfire cyl #5
OA: precat 02 sensor cyl 1-4
3E:misfire EML signal
8B: Electrical thermostat control final stage

Then i cranked it up about an hour later, then hooked up the code reader again and ran it, and only this code shows now.

8B-Electrical thermostat control final stage


Did it reset them or wtf.

Any help would be appriciated, and ive searched the forum but nothin this detailed. thanks