So story is the usual....ABS trio of lights are on...ABS module rebuilt (and tested before leaving Modulemaster)...into the car and the lights are still on....etc,.

I was going to pull the left ABS sensor since I don't have speedo (but do have cruise) and it crumbled to dust. I just got the new part in.

Before I screw something up, I need advice. Seeing as the two pins in the blue connector can be fragile, anyone have advice on how to replace this end.

I noticed my right rear sensor was resting somewhere in the wheel well. I didn't get a close look, but it was definitely different than the left rear which seemed like it was dangling. I think the boxes that hold the sensors are only for the front end?

Anyway, if someone can get me advice for how to connect it with confidence that would be cool....don't have too much slack...I can just barely get my forearm to the blue connector.