Will a E34 M5 flywheel fit on my euro 3.2L M3 engine?

[Gez]

Hi, i recently purchased a euro M3 engine and i want some advice on a good flywheel and clutch setup? Will the E34 M5 flywheel work?

Here is the engine :)

Wiring harness - to be fitted before the engine install

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0156.jpg

I removed the throttle bodies and gave them a good clean

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0157.jpg

Engine pic without the throttle bodies

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0158.jpg

Throttle bodies all cleaned up and fitted

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0159.jpg

Fuel rail and injectors installed

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0160.jpg

http://i246.photobucket.com/albums/gg98/gez-dtm/DSCF0161.jpg

[NeilM]

Hi, i recently purchased a euro M3 engine and i want some advice on a good flywheel and clutch setup? Will the E34 M5 flywheel work?

If you mean an actual E34 M5 flywheel, taken from that car, then no. The ring gear is one tooth off compared to an E36. Leads to nasty grinding noises.

If you mean a hybrid lightweight flywheel/E34 sprung clutch setup, such as those from UUC, then I don't see why not, since the stock US and Euro flywheel and clutch parts are interchangeable. But I'd check with UUC to be sure.

Neil

[Rob Levinson]

If you mean a hybrid lightweight flywheel/E34 sprung clutch setup, such as those from UUC, then I don't see why not, since the stock US and Euro flywheel and clutch parts are interchangeable. But I'd check with UUC to be sure.

Neil

The UUC Stage2 M5 conversion setup is 100% compatible with the Euro motor and also with the Euro 6-speed.

Details:

http://www.uucmotorwerks.com/flywheel/LFWLE36SH.htm