Cup holder clips

[chadwick405]

My cup holders are all there, its just the little clips that hold the drink in place are missing I was wondering if you guys knew where I could get some new ones.

[Ron97M3]

The cupholders unclip by squeezing on their sides with thumb and forefinger
and pulling up and out.

The drink clips are a built in part of the cupholder I think you will find.
The prior owner of my M3 had partially broken mine somehow and used duct tape to poorly of fix. I used loctite plastic epoxy from target ($3) so weld the plastic back together the right way. If you had the plastic pieces you could do the same. That loctite stuff is the way to go for gluing plastic.

[chadwick405]

Well one of the four in one of my cup holders is loose and i checked it out, it just needs to be glued, the other one has no clips. So I guess I need the whole cup holder part know where to buy?

[chadwick405]

found one on ebay, but its like 30 bucks.

[Ron97M3]

There is a new one for $16 at rmeuropean.com
http://www.rmeuropean.com/index.asp?PageAction=VIEWPROD&ProdID=2079

FYI this beats the new one on ebay buy it now for $25.

[Winter]

There is a new one for $16 at rmeuropean.com
http://www.rmeuropean.com/index.asp?PageAction=VIEWPROD&ProdID=2079

FYI this beats the new one on ebay buy it now for $25.
good deal

[chadwick405]

O yah much better, thanks, btw i did that group buy u recommended and replaced the whole cooling system.

[chadwick405]

Ok sweet just ordered 2, for that price ill just replace them both.