borealiss
07-18-2007, 01:54 AM
unfortunately it is time for me to sell my car.
127,000 miles.
the good:
active autowerke twinscrew level 2 http://forums.bimmerforums.com/forum/showthread.php?t=583556&highlight=twinscrew+install
active autowerke differential support bracket
PWR 57 mm racing radiator
SPAL electronic fan
VPD oil cooler
ground control shims
dinan strut bar
oem xbrace
stewart water pump
rogue engineering rear shock mounts
bilstein sport struts
VAC oil pump nut w/ loctite, swaged threads, and lock wired in
VAC oil pan baffle
custom midpipe exhaust w/ 2 vibrant 2.5" racing cats
kenwood 4 channel amp, eclipse sub amp
xm satellite radio
HID's
6 speaker infinity sound system
10" infinity subwoofer
top end rebuild done by evosport
-new valve seats, new springs, new hardened retainers, and lifters
will also include water/methanol injection kit
original paint
all original VINs on panels
350rwhp, 301rwtq @ 10.5 psi (261 rwtq at 2500 rpms!)
the bad:
passenger side door panel is bubbling
rear tires need replacing
speedometer just went south, but i have a replacement diff speed sensor
here's the dyno that was done at American Racing Technology
http://www.geocities.com/borealiss/stg2.5.jpg
I will include other images soon.
Starting at $23,000. PM me if you are SERIOUS only, otherwise please do not waste my time. TIA.
Car is located in Austin, Texas.
Eric
127,000 miles.
the good:
active autowerke twinscrew level 2 http://forums.bimmerforums.com/forum/showthread.php?t=583556&highlight=twinscrew+install
active autowerke differential support bracket
PWR 57 mm racing radiator
SPAL electronic fan
VPD oil cooler
ground control shims
dinan strut bar
oem xbrace
stewart water pump
rogue engineering rear shock mounts
bilstein sport struts
VAC oil pump nut w/ loctite, swaged threads, and lock wired in
VAC oil pan baffle
custom midpipe exhaust w/ 2 vibrant 2.5" racing cats
kenwood 4 channel amp, eclipse sub amp
xm satellite radio
HID's
6 speaker infinity sound system
10" infinity subwoofer
top end rebuild done by evosport
-new valve seats, new springs, new hardened retainers, and lifters
will also include water/methanol injection kit
original paint
all original VINs on panels
350rwhp, 301rwtq @ 10.5 psi (261 rwtq at 2500 rpms!)
the bad:
passenger side door panel is bubbling
rear tires need replacing
speedometer just went south, but i have a replacement diff speed sensor
here's the dyno that was done at American Racing Technology
http://www.geocities.com/borealiss/stg2.5.jpg
I will include other images soon.
Starting at $23,000. PM me if you are SERIOUS only, otherwise please do not waste my time. TIA.
Car is located in Austin, Texas.
Eric