clutch has no pressure??

[bloxsom]

i just pull out the trans (5spd) and after i put it back in i pressed the clutch petal in and its like there is nothing there. there is no force pushing back, it just sits on the floor. whats rong??
is there a way that you can put the slave silinder in wrong?
please help
chris

i didnt not open up any lines so i dnot think there is any air in it.

[FierySphere]

Did you check that you have pressure at the clutch fork? Maybe the fork slipped of the pivot inside the housing?

Did you re-bled the slave cylinder, to test operation ? I'd try that to ensure that you know the state of the slave cylinder before going to much further.

[bloxsom]

i just bled it and it works great.
but if i never opend up the line how would it get air in it?

[FierySphere]

It's just one of those questions...
Like why do you never see baby pidgeons? And what the heck are 'jumbo shrimp' ?

[bmwbachelor]

make sure the fluid is topped up and start pumping the clutch peddle for 3 to 5 minutes (boring). This is assuming the fork is properly set and it is bled.