wheel bearing idea

[93bmw325is]

ok so i need a new wheels bearing.but i have a whole parts car.so i was thinking acn i just take some osrt of assembly off the other car and bolt it on mine.is it easy do i nedd any special tools?the parts car i have the wheel bearings were just relaced and onl have 2k on them tops.thanks for any info or help.
almost forgot this is a rear wehhle bearing and my car is a 93 325is and the parts car is a 94 325i

[Beamin']

ok so i need a new wheels bearing.but i have a whole parts car.so i was thinking acn i just take some osrt of assembly off the other car and bolt it on mine.is it easy do i nedd any special tools?the parts car i have the wheel bearings were just relaced and onl have 2k on them tops.thanks for any info or help.
almost forgot this is a rear wehhle bearing and my car is a 93 325is and the parts car is a 94 325i
splell cheacke is yur freined.

I need new wheel bearings too, but thats up front. If you had bearing issues in the back, wouldnt the CV joints need replacing?

[93bmw325is]

i dont think so..but i get the wha wha wha noise and it increases with speed and then some cray vibratiion after 45 mph.

[SecretAznSauce]

splell cheacke is yur freined.

I need new wheel bearings too, but thats up front. If you had bearing issues in the back, wouldnt the CV joints need replacing?


negative,the axles just pop out, to do the rear like you mention, you will have to pull the entired Rear trailing arm, that includes the hub, the bearing etc.

[kinghawk]

only draw back of doing this is needing a 4-wheel alignment after doing the swap