View Full Version : Idle Question
Ted K
11-26-2004, 01:06 AM
I now have had my 90 535 5 speed for a couple of months. Today I noticed when I start it and its cold it idles at 750. When it warms up it idles at 1000. It is smooth at both settings.
Is this normal? If not what would be the first thing to check and how. Bentley talks a little about checking to see if the throttle position sensor and switch are working properly. So please point me in the right direction.
Thanks
liquidtiger720
11-26-2004, 01:48 AM
as stupid as it sounds. check your floor mat =).
Ted K
11-27-2004, 02:10 AM
I did check this, this morning. It seems to be adjusted right for the idle. Bentley (130-8) says to check for continuity for idle between pins 2 & 18. This checked out Ok When checked between pins 3 & 18 Full throttle I did not get anything. So this looks like a possible bad part.
I also checked the idle speed control valve Bentley 130-12. I did not notice it buzzing during idle. When checking the coil resistance I did not get the values listed in the table. I only have an old meter that I do not trust. I hope I do not have two bad parts. Is it common for both these to go out?
My fuel mileage has been around 19 for all around driving by the computer. The car seems to be running good. No codes
Kdog2112
12-08-2004, 10:29 PM
no he meant check your floor mat to make sure its not touching or pressing in the gas pedal,,,,,,make sure itsin the propercondition...it can get out of place and press against the pedal
Powered by vBulletin® Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.