b2ke
02-22-2021, 10:52 PM
1. Should I swap out the internal vacuum hose from inside the M62TU intake manifold into the M60B40 intake manifold? I've been finding conflicting info on this.
2. There is some glue inside the M60B40 intake manifold that I am assuming is holding the velocity stacks trumpet in place, I wonder if anyone could explain this? I'm guessing maybe the "trumpets" fell out at some point in time and were glued back or there is a chance it is factory. I actually have TWO M60B40 intake manifolds on hand and one of them does NOT have this brown glue, however, the other (pictured) does.
686078
Thank you!
2. There is some glue inside the M60B40 intake manifold that I am assuming is holding the velocity stacks trumpet in place, I wonder if anyone could explain this? I'm guessing maybe the "trumpets" fell out at some point in time and were glued back or there is a chance it is factory. I actually have TWO M60B40 intake manifolds on hand and one of them does NOT have this brown glue, however, the other (pictured) does.
686078
Thank you!