PDA

View Full Version : Some help Im sorta lost



streetmedic
09-09-2019, 11:31 PM
I have o8 535i that started to get a misfire on #2 so i started att he plugs and still cont.
then re[placed all coil packs.
Still had the hiccups and misfires. so i went to using inpa ect ect.

The read outs showd that my injector was the problem so i bought one and yes its a index 11 and i re modified the the settings via inpa for the injector.. . the problem went away till i was on on vacation and i popped a hole in my oilr cooler..
replaced that and what a nightmare that was over past months hoiliday.
but now that its all fixed i was getting a #6 error codes for p0306 and p142E and p140E turns out my spark plug porcelon was chipped and stuck in the head of the plug .

So i was having in the back of my head fuel issues so i replaced the driver rear under the seat. all minor issues aside i did a

and now the car idles fine no more hiccups

till now it just dies ... here is my read with carly


runs for a few seconds 15 or so then dies ..MY question since ive fixed alot of things and i getting a bit tapped on finaces is this my lpfp sensor or is it fuel pump hpfp or the one under the passenger seat.

i see it says low pressure but i find its not always what it says with a bmw. Im can work and fix things no problem but decifering this i need to ask opinions please...

Is this a HPFP or lpf sensor or is this lpfp? or

Faultcode: (0x2A2D) Low-pressure fuel system, fuel pressure
Faultset 1:
(appeared at: 203016.0km)
Fuel pressure before quantity control valve:
1680.00 hPa
Engine speed:
640.00 rpm
Voltage cl. 87:
14.02 V
inserted syringe fuel mass:
2.00 l/h

Faultcode: (0x2AAF) Fuel pump, plausibility
Faultset 1:
(appeared at: 203016.0km)
Fuel pressure before quantity control valve:
14.02 V
1260.00 hPa
Engine speed:
992.00 rpm
Voltage cl. 87:
inserted syringe fuel mass:
4.00 l/h

Faultcode: (0x29DC) Cylinder injection cut
Faultset 1:
(appeared at: 203016.0km)
Fuel tank level:
13.00 l
calculated air mass:
440.00 mg/stk
Engine speed:
1344.00 rpm
engine temperature:
81.75 °C

- - - Updated - - -

ill do another scan in the morning my battery died and have to charge it up over night
\

streetmedic
09-14-2019, 01:28 AM
So since i did not get any help like i was hoping on this forums i found a solution from a online diagnstic web site and i am glasd i used his service because its the most complete and exact help no BS with it may be this try this crap itsw exactly how to diag the prob with INPA and well read my write up on his service and I wont hesitate to use him again ..https://www.bimmerforums.com/forum/showthread.php?2413364-IF-your-stuck-read-this-it-may-make-your-day-like-it-did-mine

Total time to fix 45 mins and 2 hours to make the images for diag seesion and 200.36 cost to buy a new LPFP from fcpeuro

CLosed this thread please