WTB getrag 265 parts

[86GT635]

Looks like I need
2 angled transmission mounts
1 rear buffer bushing(body to shift plate)
1 shift selector rod 147mm straight
1 selector rod joint to transmission
1 foam/rubber insulation
1 rubber seal to body
6 flywheel to crank bolts
1 ring for the flywheel bolts
6 quibo bolts/nuts
1 clutch master cylinder e28 based
1 master to slave hard line
1 soft slave line

Prefer BMW parts new or lightly used.

[FernandoBunster]

It's all available from dealer or the usual parts suppliers. I got most of my parts from Maximillian. http://www.bmwmobiletradition-online.com/

[86GT635]

Yea, I don't know if the rubber foam is though. I think the Hardline from master to slave is NLA, along with the foam.

I just bought a brand new center bearing and lightly used fte slave for $70- the bearing is 125 now, slave is 107. $230 is a little different from 70 haha.

Just seeing if anyone has any of these parts before buying new.

[alpinacsi]

I have new hard lines and flywheel bolts. Most likely have the plate for the bolts. Might have the foam as I bought 2 by mistake late last year.

[FernandoBunster]

Yea, I don't know if the rubber foam is though. I think the Hardline from master to slave is NLA, along with the foam.

I just bought a brand new center bearing and lightly used fte slave for $70- the bearing is 125 now, slave is 107. $230 is a little different from 70 haha.

Just seeing if anyone has any of these parts before buying new.

Maximillian is still showing the foam insulation and hardline as available.

[86GT635]

Looks like I found the cylinders and lines.

Still looking for the hardware, shifter selector rod, mounts and foam isolator/rubber gasket seal.