Powerflex RTAB Install Problem

[rajicase]

I am having an issue installing my powerflex rtabs. I have lubed then up liberally. The bushing that goes into the front of the trailing arm went in smoothly without much effort. The bushing that goes in through the back won't go in, no matter how much I push, pull, hammer, etc.. Its the same on both the right and left side of the car. I thought these were supposed to go in easily?(the front half did), and when I try hammering them in, the trailing arm cuts into the poly.. Any help??

[jorbennett]

I had the same problem installing mine a few months back. What I did was install the front half, then line up the rear half and use a large c-clamp and 2 small pieces of wood to put even pressure on it while keeping an eye on it to make sure its going in evenly.

[pussiwillow]

Same issue here, used the c clamp with 2 small planks of wood on either side, went right in