Euro Oil filter housing

[lightingflash]

E36 euro oil filter housing that has been professionally tapped and threaded. The 2 ports for the oil cooler lines have been tapped. One is M16x1.5 and the other is M14X1.5. There are adapter readily available to convert from M16 and M14 to AN-10. They are like $9 each. This would allow someone to easily set up AN-10 lines for a custom oil cooler install.

The Vanos port has not been tapped. It is still M12, so you would either run a VAC or Bimmerworld Banjo bolt or drill and tap it out to M14.

The thermostat has been removed so this it perfect candidate for a diverter valve which allows full flow to the oil cooler.

Just did a very similiar install on my car.

SOLD

thanks

Brian

[lightingflash]

OR best offer - bump

[E36Shikara]

I offer you my lifelong point bys on track plus the cost of shipping..

lifelong friendship too..along with a subwoofer and amplifier..

[lightingflash]

I offer you my lifelong point bys on track plus the cost of shipping..

lifelong friendship too..along with a subwoofer and amplifier..

"good offer", but not quite the "best offer"..:)

SOLD!!

[E36Shikara]

Awesome..ill still give you point bys though..you're wicked fast with those rcomps..