karl530
10-27-2012, 12:31 PM
Good day,
Have finally managed to install INPA / DIS and SSS but keep getting errors when attempting to code via NCS Expert DIS and SSS
This is on a win 7 32 bit system using the diaghead emulator.
The error from sss is the following "VIN and ZCS/FA cannot read out from EWS/KMB/LSZ control unit"
NCS Expert will get the vin and other data that appears in the middle when attempting to read but will go no further than that.
I feel I am close but I can't manage to get past these issues.
Any help appreciated.
Thanks Karl
Have finally managed to install INPA / DIS and SSS but keep getting errors when attempting to code via NCS Expert DIS and SSS
This is on a win 7 32 bit system using the diaghead emulator.
The error from sss is the following "VIN and ZCS/FA cannot read out from EWS/KMB/LSZ control unit"
NCS Expert will get the vin and other data that appears in the middle when attempting to read but will go no further than that.
I feel I am close but I can't manage to get past these issues.
Any help appreciated.
Thanks Karl