Rear bumper

[spinelli911]

Does anyone have a DIY guide to removing the rear bumper?
Everything below the tail lights.

All input is much appreciated

[purplecty]

Its on here... Do a search... Maybe in DIY section...

[RIboater]

Remove 2-3 bolts from the inside rear fender wells. You may have some bolt heads and some plastic rivet pop outs. Remove the black trim from the bumper by pulling out/up hard. Once removed look down through the holes and you'll see two large torx bolt heads. Trick is pulling them up and out once unscrewed. Then bumper just slides off.

[Don Molina]

1x8mm in each fender well and 3 or 4 plastic clips that you can pull out.
Then the lining is free from the bumper and you only have to undo the 2 big screws that bolt on the shock absorbers.
In my fl they're hex sockets.
They need a little shake and banging to come out, but you'll get it done.

Just have a second guy to slide the bumper out with, it's kinda cumbersome to handle alone. And for re-installing you'll definetely need a second guy just to put it in its rails :)