2 door power vent convertion

[albanator1979]

I have the motors wires/cables, mounting hard wear and switches for the install/convertion. I have the wires that run under the seats to the rear motors (uncut)and up to the switches(witch I cut to get out. But they are color to same color for install) I cut the wires that went to the bundle under the dash so you will have to make them longer, But they all went color coded to the bus bars. I will label the wires on what side I cut to get it out so will be an easy install. I can also tell you/send you pics of how it came out to make things easy for who ever wants the set up. This is a direct plug it in mount and enjoy power rear vents... I will upload a picture here in a min once I fig out how.

[NeonStatus]

How is it plug and play if you cut the wires?

How much do you need for everything?

[albanator1979]

it is plug and play by just reconnecting the wires....the wires are color coded so putting eveything back in would be as simple as install motors, run wires under the carpet, match color wire (witch i can soder heat shrink back if you would like, but running the wires under the carpet/seat will be a sinch with them the way they are.) put in the switches,install the rear vent hinges, run the cable to motor(witch can only go one way) and that is all. I can do a DIY with pics and email it to who ever buys it to aid in the install. I have done a few searches for them and i have seen 325-350 plus shipping. I am open for offers but i would like a fair price but not looking to gouge ether. 275-300 shipped is what i was thinking.

[albanator1979]

Bump

[albanator1979]

Sold mods please close