After NCS coding false broken lamp light on

[buzz2912]

Hi,

tried to code my e85 2007 today. Worked, but it didn't let me code the ALSZ. Don't know why.
I tried to use the expertenmodus profile but then changed to revtor's profile. I don't know what happend next but know though my angel eyes both work, the blinking lights are on as well and naturally the light for the a broken bulb.

What happend? What can I do?
Please help! Revtor?

Sebastian

[Rubiyy387]

Recode again with expertenmodus. And dont't use ncs and like ncs tools unless you know what you do.

[rondo]

Hi dont panic the solution is to recode the LSZ module to your VO.This is like a factory reset.
Load the expertmode profile enter chassis etc. choose ecu[ LKM].verify that job name is SG_CODIEREN then F3 should reset your module to the factory default..:D

[buzz2912]

All right, thanks.

What I did was coding something in carmemory and everything was good again. The lamps worked normally.
I can reproduce the problem everytime I try to code the ALSZ. Same fault. When I read the ALSZ is always says coding erfolgreich. I tried to code the eu daytime running lights today. There are two things to change which I did. After the coding it stopped with coding done and the turning signals came on but no daytime running lights. I reread the ALSZ and all was aktiv. The coding had worked. To make the turning signals come off I recoded the cyclic blinking again in carmemeory which was off. Worked. Turning signals off. Reread the ALSZ. Still Dauerfahrlicht EU aktiv and ECE lights aktiv but no daytime running lights on.

I have no idea what I am doing wrong. The car was precoded from a guy who worked a BMW when I bought it. Maybe something was wrong before.

Thats why Im thinking of setting it back to factory defaults.

Any ideas?

Thanks, Buzz

[Cardedon]

Hi, someone have winKFP 5.1 in english?
I have found only a old version that is in german.
Please pm me if you can give me the software